Voice OTP settings
Voice providers are used to send voice OTPs. There are two options for sending voice messages:
-
Default—No Voice OTP gateway. However, Voice OTP settings are inherited from the parent Virtual Server if they are configured.
-
Custom—Select this option to configure the Virtual Server to send voice messages via a service provider to which you have subscribed. You can verify the ability to send voice messages by entering the phone number of a device capable of receiving voice messages in the Sender's Phone Number field.
Prior to configuring SAS, configure a custom voice provider. The voice provider that you configure applies to the organization and its sub-organizations.
You can also customize the voice OTP messages that the Virtual Server sends.
Configure SAS to use a custom voice provider
To configure SAS to use a custom voice provider:
-
On the SAS console, select Comms > Communications > Voice OTP Settings.
-
Select Custom.
-
Provide the details about the voice provider that you are using:
-
Voice Provider—Twilio.
-
Account Id—Provided by Twilio.
-
Authentication Token—Provided by Twilio.
-
Sender's Phone Numbers—Provided by Twilio. The numbers from which you will receive calls.
Phone numbers must contain digits only and must begin with a country code.
-
Delay between messages (ms)—The delay between calls in milliseconds.
The only voice provider supported is Twilio. Refer to Twilio for details.
-
-
Select Apply.
Recommended settings
The recommended settings are:
-
SMS template in Challenge Response mode
-
Numeric PIN's only (complex PINS are not supported)
Related information
Other tasks related to the Voice OTP feature include:
