hsm time sync

Synchronize the current HSM time with the current host time.

Automatic HSM time synchronization depends on the HSM and Host clocks being no more than 3 seconds out-of-sync. If the difference is greater, you can use this command to 'manually' synchronize the two, after which daily automatic synchronization can carry on.

NOTE   The hsm commands appear only when LunaCM's active slot is set to the administrative partition on a Luna PCIe HSM 7 or Luna USB HSM 7 or Luna Backup HSM. To access the HSM-level commands on Luna Network HSM 7, use LunaSH (see hsm). The hsm time commands are available for HSMs with Luna Appliance Software 7.8.0 or newer and Luna HSM Firmware 7.8.0 or newer.

Once hsm time sync has been executed, the System Times information also appears in the command output for:

>lunash:> hsm show

>lunacm:> partition showinfo

The HSM SO must be logged in, to use this command.

Syntax

hsm time sync

Example

lunacm:> hsm time sync

HSM time was synchronized to Host

Command Result : No Error