hsm time sync

Synchronize the current HSM time with the current host time.

Automatic HSM time synchronization depends on the HSM and Host clocks being no more than 3 seconds out-of-sync. If the difference is greater, you can use this command to 'manually' synchronize the two, after which daily automatic synchronization can carry on.

NOTE   The hsm commands appear only when LunaCM's active slot is set to the administrative partition. The hsm time commands are available for HSMs with Luna HSM Firmware 7.8.0 and newer.

The System Times block is also part of the hsm showinfo and partition showinfo lunacm command outputs for all PPSO firmware versions (6.22.0 and up) and 7.0 and up.

The HSM SO must be logged in, to use this command.

Syntax

hsm time sync

Example

lunacm:> hsm time sync

HSM time was synchronized to Host

Command Result : No Error