Display the current network bonding interface status.
User Privileges
Users with the following privileges can perform this command:
>Admin
>Operator
>Monitor
Syntax
network interface bonding show
Example using Luna Appliance Software 7.9.0 or newer
lunash:>network interface bonding show bond0: Bonding Mode: fault-tolerance (broadcast) MII Status: up MII Polling Interval (ms): 500 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:b2:ad:40:7c Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:b2:ad:40:7d Slave queue ID: 0 Slave status eth0: Link detected: yes Slave status eth1: Link detected: yes ----------------------------------------------------------- bond1: Bonding Mode: fault-tolerance (broadcast) MII Status: up MII Polling Interval (ms): 500 Up Delay (ms): 0 Down Delay (ms): 0 Slave Interface: eth2 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:b2:ad:40:7e Slave queue ID: 0 Slave Interface: eth3 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:b2:ad:40:7f Slave queue ID: 0 Slave status eth2: Link detected: yes Slave status eth3: Link detected: yes ----------------------------------------------------------- Command Result : 0 (Success)
Example using Luna Appliance Software 7.8.5 or older
lunash:>network interface bonding show bond0: Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth1 MII Status: up MII Polling Interval (ms): 0 Up Delay (ms): 0 Down Delay (ms): 0 ARP Polling Interval (ms): 500 ARP IP target/s (n.n.n.n form): 192.20.11.10 Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 1 Permanent HW addr: 00:15:b2:a9:b7:85 Slave queue ID: 0 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 00:15:b2:a9:b7:84 Slave queue ID: 0 Slave status eth0: Link detected: yes Slave status eth1: Link detected: yes ----------------------------------------------------------- bond1: bond1 is configured, but not enabled. Bonding Interface: bond1 Slave devices: eth2 eth3 ----------------------------------------------------------- Command Result : 0 (Success)
