network interface dhcp

Configure the network interface to request a dynamic IP address.

NOTE DHCP is not recommended.

admin, pseoperator

network interface dhcp -device <netdevice> [-force]

Argument(s)	Shortcut	Description
-device <netdevice>	-d	Specifies the interface you want to configure to use DHCP. Valid values: eth0, eth1
-force	-f	Force the action without prompting for confirmation.

Argument(s)

Shortcut

Description

-device <netdevice>

-d

Specifies the interface you want to configure to use DHCP.

Valid values: eth0, eth1

-force

-f

Force the action without prompting for confirmation.

psesh:>network interface dhcp  -device eth0

NOTICE: The network service must be restarted for new network settings to take effect.

If you are sure that you wish to restart the network, then type 'proceed', otherwise type 'quit'

> proceed

Proceeding...

e1000e: eth0 NIC Link is Down

Restarting network service...

Shutting down loopback interface:                         [  OK  ]

Bringing up loopback interface:                           [  OK  ]

Bringing up interface eth0:

Determining IP information for eth0...ADDCONF(NETDEV_UP): eth0: link is not ready

e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None

ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

done.

                                                          [  OK  ]

Command Result : 0 (Success)