SERIAL_SetMode

Used to set the serial port communication parameters.

Synopsis

int SERIAL_SetMode( int port, 
int baud, 
int numBits, 
SERIAL_Parity parity,
int numStop, 
SERIAL_HSMode hs);
 

Parameters

Parameter	Description
port	Serial port number (0 based). Specify port 0 to redirect the output to the hsmtrace log.
baud	Baud rate.
numBits	Number of bits in a character. Should be 7 or 8
parity	One of the following: >SERIAL_PARITY_NONE >SERIAL_PARITY_ODD >SERIAL_PARITY_EVEN >SERIAL_PARITY_ONE >SERIAL_PARITY_ZERO
numStop	Number of stop bits in a character. Should be 1 or 2
hs	Handshake type. Should be one of the following: >SERIAL_HS_NONE >SERIAL_HS_RTSCTS >SERIAL_HS_XON_XOFF

NOTE   Serial flow control is not implemented in the current HSM firmware. This value should be set to SERIAL_HS_NONE.

Return Code

0: Mode changed successfully

-1: There was an error