Installing the Luna USB HSM 7 Hardware

This section describes how to connect the Luna USB HSM 7 to a client computer.

Prerequisites

>Ensure that the Luna HSM Client software with the USB option is installed on the client (see Luna HSM Client Software Installation). This includes the necessary device drivers.

NOTE   If you are installing Luna HSM Client on Windows, the driver may not be installed unless the Luna device is connected to the computer first; refer to Backup/USB/PCIe Drivers Not Installed on Windows 10 or Windows Server 2022 Unless Device is Connected.

To connect the Luna USB HSM 7 to a client

1.Use the included USB-C to USB cable to connect the Luna USB HSM 7 to a USB port on the client computer.

NOTE   On most Luna HSM Client computers, the USB port provides adequate power, and connecting the provided power supply is not recommended. Wait and confirm that the HSM boots properly. If the HSM fails to boot up:

1. Disconnect the HSM from the USB port.

2. Connect the HSM to power using the provided power supply. Wait for it to boot completely.

3. Reconnect the HSM to the USB port on the client.

If the HSM is connected to the USB port before the power supply, you may encounter an issue where the HSM occasionally loses contact with the client, and must be power cycled.

2.Run LunaCM on the client computer to ensure the Luna USB HSM 7 is visible to the client.

        Available HSMs:

        Slot Id ->              4
        Label ->
        Serial Number ->        556677
        Model ->                Luna G7
        Firmware Version ->     7.7.2
        Bootloader Version ->   1.6.0
        Configuration ->        Luna HSM Admin Partition (PW) Key Export With Cloning Mode
        Slot Description ->     Admin Token Slot
        HSM Status ->           L3 Device, Zeroized



        Current Slot Id: 4