hsm ped disconnect

For legacy connections only. Disconnect the current/active remote PED. No address information is required since only one remote PED connection can exist at one time.

To disconnect the PED when using a peer-to-peer connection, you must first disconnect from peer mode and return to legacy mode.

NOTE   To set up or erase a PED vector, or to make or break the Remote PED connection, on an HSM that is externally connected to the Luna Network HSM, use the "-serial" option to specify the target HSM. If "-serial" is not specified, then the command acts on the Luna Network HSM's internal HSM card.

User Privileges

Users with the following privileges can perform this command:

>Admin

>Operator

Syntax

hsm ped disconnect [-serial <serialnum>] [-force]

Argument(s) Shortcut Description
-force -f Force the action without prompting.
-serial <serialnum> -s Token Serial Number

Example

lunash:>hsm ped disconnect

If you are sure that you wish to disconnect, then enter 'proceed', otherwise type 'quit'.

> proceed
Proceeding...


Command Result : 0 (Success)