Ending or Switching the Remote PED Connection
PEDserver runs on the Remote PED host until explicitly stopped. PEDclient (running on the Luna Network HSM)
To end or switch an HSM-initiated Remote PED connection using LunaSH
1.End the Remote PED connection.
lunash:> hsm ped disconnect
2.You are now able to initiate a connection to a different Remote PED host running PEDserver. You will need to present the orange PED key.
lunash:> hsm ped connect -ip <PEDserver_IP> -port <port>
NOTE Running this command does not change the default Remote PED IP/port you may have previously set. If you want this new Remote PED server to be the default, set it using lunash:> hsm ped set -ip <PEDserver_IP> -port <port>.
To end or switch an HSM-initiated connection using LunaCM
1.End the Remote PED connection.
lunacm:> ped disconnect
2.You are now able to initiate a connection to a different Remote PED host running PEDserver. You will need to present the orange PED key.
lunacm:> ped connect -ip <PEDserver_IP> -port <port>
NOTE Running this command does not change the default Remote PED IP/port you may have previously set. If you want this new Remote PED server to be the default, set it using lunacm:> ped set-ip <PEDserver_IP> -port <port>.
To end or switch a PED-initiated Remote PED connection
1.End the Remote PED connection with the current host ().
lunash:> hsm ped deselect -host <server_name>
2.Check the available list of Remote PED servers.
lunash:> hsm ped server list
If the Remote PED you want to use is not in the list, see PED-Initiated Remote PED.
3.The new Remote PED server must initiate the connection to the appliance.
> pedserver mode connect -name <appliance_name>
4.In LunaSH, you are now able to select the new Remote PED server from the available list.
lunash:> hsm ped select -host <server_name>
