Ending or Switching the Remote PED Connection

PEDserver runs on the Remote PED host until explicitly stopped. PEDclient (running on the SafeNet Luna Network HSM) behaves differently depending on the type of Remote PED connection. If you want to connect to a different Remote PED server, or allow another HSM to use the current server, you must manually break the Remote PED connection.

To end or switch an HSM-initiated Remote PED connection using LunaSH

1.End the Remote PED connection (hsm ped disconnect).

lunash:>hsm ped disconnect

lunash:>hsm ped disconnect

If you are sure that you wish to disconnect, then enter 'proceed', otherwise type 'quit'.

> proceed

Proceeding...

Command Result : 0 (Success)

2.You are now able to initiate a connection to a different Remote PED host running PEDserver (hsm ped connect). You will need to present the orange PED key.

lunash:>hsm ped connect -ip <PEDserver_IP> -port <port>

NOTE Running this command does not change the default Remote PED IP/port you may have previously set. If you want this new Remote PED server to be the default, set it using ped set -ip <PEDserver_IP> -port <port>.

To end or switch an HSM-initiated connection using LunaCM

1.End the Remote PED connection (ped disconnect).

lunacm:>ped disconnect

lunacm:> ped disconnect

        Are you sure you wish to disconnect the remote ped?

        Type 'proceed' to continue, or 'quit' to quit now -> proceed

Command Result : No Error

2.You are now able to initiate a connection to a different Remote PED host running PEDserver (ped connect). You will need to present the orange PED key.

lunacm:>ped connect -ip <PEDserver_IP> -port <port>

To end or switch a PED-initiated Remote PED connection

1.End the Remote PED connection with the current host (hsm ped deselect).

lunash:>hsm ped deselect -host <server_name>

lunash:>hsm ped deselect -host RemotePED1

Command Result : 0 (Success)

2.Check the available list of Remote PED servers (hsm ped server list).

lunash:>hsm ped server list

If the Remote PED you want to use is not in the list, see PED-Initiated Remote PED.

3.The new Remote PED server must initiate the connection to the appliance (pedserver mode connect).

>pedserver mode connect -name <appliance_name>

4.In LunaSH, you are now able to select the new Remote PED server from the available list (hsm ped select).

lunash:>hsm ped select -host <server_name>