sysconf drift set

Manually set the internal drift measurement data.

User Privileges

Users with the following privileges can perform this command:

>Admin

>Operator

Syntax

sysconf drift set

Example

lunash:>sysconf drift set
 
 
   Enter the value to be used for drift (in seconds per day): 3
 
   This value will overwrite the previous value of the drift that may have
   been measured.  If you are sure that you wish to overwrite it, then type
   'proceed', otherwise type 'quit'
   > proceed
   Proceeding...
 
   NOTE: The new value will not take effect until 'sysconf drift init' is run.
 
 
Command Result : 0 (Success)