status interface

Display network interface information.

User Privileges

Users with the following privileges can perform this command:

>Admin

>Operator

>Monitor

Syntax

status interface

Example

lunash:>status interface

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN

    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

    inet 127.0.0.1/8 scope host lo

       valid_lft forever preferred_lft forever

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000

    link/ether 00:15:b2:a9:b7:84 brd ff:ff:ff:ff:ff:ff

    inet 192.20.11.78/24 brd 192.20.11.255 scope global dynamic eth0

       valid_lft 107785sec preferred_lft 107785sec

3: eth1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN qlen 1000

    link/ether 00:15:b2:a9:b7:85 brd ff:ff:ff:ff:ff:ff

4: eth2: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN qlen 1000

    link/ether 00:15:b2:a9:b7:86 brd ff:ff:ff:ff:ff:ff

5: eth3: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc mq state DOWN qlen 1000

    link/ether 00:15:b2:a9:b7:87 brd ff:ff:ff:ff:ff:ff

Command Result : 0 (Success)