network interface bonding show
Display the current network bonding interface status.
User Privileges
Users with the following privileges can perform this command:
>Admin
>Operator
>Monitor
Syntax
network interface bonding show
Example
lunash:>network interface bonding show
bond0:
Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth1
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0
ARP Polling Interval (ms): 500
ARP IP target/s (n.n.n.n form): 192.20.11.10
Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: 00:15:b2:a9:b7:85
Slave queue ID: 0
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:15:b2:a9:b7:84
Slave queue ID: 0
Slave status eth0: Link detected: yes
Slave status eth1: Link detected: yes
-----------------------------------------------------------
bond1:
bond1 is configured, but not enabled.
Bonding Interface: bond1
Slave devices: eth2 eth3
-----------------------------------------------------------
Command Result : 0 (Success)