sysconf ntp addserver

Add an NTP server. NTP will automatically synchronize with the highest-stratum server you add. If none of these servers are accessible, NTP will synchronize with the local clock, and may be subject to drift.

A DNS name server must be configured if you add an NTP server by hostname.

User Privileges

Users with the following privileges can perform this command:

>Admin

>Operator

Syntax

sysconf ntp addserver <hostname_or_ipaddress> [-autokey | -key <keyid>] [-burst] [-iburst] [-prefer] [-version <version>]

Option	Shortcut	Description
<hostname_or_ipaddress>		Specifies the hostname or IP address of the NTP Server.
-autokey	-a	Send and receive packets authenticated by the AutoKey scheme (not used with -key <keyid>).
-burst	-b	Send multiple packets when the server is reachable.
-iburst	-i	Send out bursts of 8 packets when the server is unreachable.
-key	-k	Specifies the NTP Authentication key ID (not used with AutoKey) Range: 1 to 65535
-prefer	-p	Set this server as the preferred server.
-version <version>	-v	Specifies the NTP version Valid values: 3 or 4

Example

lunash:>sysconf ntp addserver time.nrc.ca

NTP server 'server time.nrc.ca' added.

WARNING !! Server 'time.nrc.ca' added without authentication.

NTP is enabled

Stopping ntpd:                                             [  OK  ]

Starting ntpd:                                             [  OK  ]

Please wait to see the result ......

NTP is running

===========================================================

NTP Associations Status:

ind assid status  conf reach auth condition  last_event cnt

===========================================================

  1  1310  9024   yes   yes  none    reject   reachable  2

  2  1311  8011   yes    no  none    reject    mobilize  1

===========================================================

Please look at the ntp log to see any potential problem.

Command Result : 0 (Success)