sysconf drift set

Home >	LunaSH Command Reference Guide > LunaSH Commands > sysconf > sysconf drift set

Manually set the internal drift measurement data.

Users with the following privileges can perform this command:

•Admin

•Operator

sysconf drift set

lunash:>sysconf drift set

   Enter the value to be used for drift (in seconds per day): 3

   This value will overwrite the previous value of the drift that may have

   been measured.  If you are sure that you wish to overwrite it, then type

   'proceed', otherwise type 'quit'

   > proceed

   Proceeding...

   NOTE: The new value will not take effect until 'sysconf drift init' is run.

Command Result : 0 (Success)