Resetting to Factory Condition

These instructions will allow you to restore your SafeNet Luna Network HSM to its original factory configuration. If you have performed firmware and software updates, those remain in place, and are not affected by this procedure. The reset commands affect contents and settings of the HSM and appliance. Reverting of software and firmware is outside their scope. You must access LunaSH via a serial console to execute hsm factoryreset.

To reset the HSM to factory condition:

1.Login as HSM SO.

hsm login

2.Reset the HSM to factory settings.

hsm factoryreset

3.Reset the appliance configuration (network settings, ssh, ntls, etc.) to factory settings.

sysconf config factoryreset -service all

4.Reboot the appliance.

SafeNet Luna Network HSM 7.0 Product Documentation
007-013576-002 Rev. A 02 June 2017 Copyright 2001-2017 Gemalto All rights reserved.