Home >

LunaSH Command Reference Guide > LunaSH Commands > hsm > hsm ped disconnect

hsm ped disconnect

Disconnect the current/active remote PED. No address information is required since only one remote PED connection can exist at one time.

Note:  To set up or erase a PED vector, or to make or break the Remote PED connection, on an HSM that is externally connected to the SafeNet Network HSM, use the "-serial" option to specify the target HSM. If "-serial" is not specified, then the command acts on the SafeNet Network HSM's internal HSM card.

Syntax

hsm ped disconnect [-serial <serialnum>] [-force]

Parameter Shortcut Description
-force -f Force the action without prompting.
-serial -s Token Serial Number

Example

lunash:>hsm ped disconnect
 
If you are sure that you wish to disconnect, then enter 'proceed', otherwise type 'quit'.
> proceed
Proceeding...
Remote PED connection closed.
 
Command Result : 0 (Success)