lunash sysconf ntp Commands
NAME
sysconf ntp status - Display NTP service status
SYNOPSIS
lunash:> sysconf ntp status
DESCRIPTION
Gets NTP service status.
A “+” in front of an NTP server name means that it’s a good candidate for synchronization. More than one NTP servers could be good candidates.
A “*” in front of an NTP server name means that the it’s the source of synchronization and the client has been synchronized to it. Only one NTP server at a time will be chosen as the source of synchronization.
OPTIONS
None
SAMPLE OUTPUT
[myluna] lunash:> sysconf ntp status
NTP is running
NTP is enabled
Peers:
==============================================================================
remote refid st t when poll reach delay offset jitter
==============================================================================
*LOCAL(0) .LOCL. 10 l 15 64 7 0.000 0.000 0.000
==============================================================================
Associations:
==============================================================================
ind assid status conf reach auth condition last_event cnt
===========================================================
1 12393 963a yes yes none sys.peer sys_peer 3
==============================================================================
NTP Time:
==============================================================================
ntp_gettime() returns code 0 (OK)
time d2407aa3.4e858000 Wed, Oct 12 2011 13:44:19.306, (.306725),
maximum error 8020716 us, estimated error 0 us
ntp_adjtime() returns code 0 (OK)
modes 0x0 (),
offset 0.000 us, frequency 0.000 ppm, interval 1 s,
maximum error 8020716 us, estimated error 0 us,
status 0x1 (PLL),
time constant 2, precision 1.000 us, tolerance 512 ppm,
==============================================================================
Command Result : 0 (Success)
[myLuna] lunash:>
.