SNMP Monitoring
This chapter describes Simple Network Management Protocol (SNMP v3) support for remote monitoring of conditions on a local HSM that might require administrative attention. It contains the following sections:
>Installing the SafeNet SNMP Subagent
>The SafeNet Chrysalis-UTSP MIB
>SNMP Operation and Limitations with SafeNet Luna Network HSM
MIB
Thales Group provides the following MIBs (management information base) in the Luna HSM Client installation package:
| MIB Name | Description |
|---|---|
| CHRYSALIS-UTSP-MIB.txt | Defines SNMP access to information about the SafeNet appliance. |
| SAFENET-HSM-MIB.txt | Defines SNMP access to information about the SafeNet Luna HSM. |
| SAFENET-GLOBAL-MIB.txt | Must be found in your system path so that symbols can be resolved. |
| SAFENET-APPLIANCE-MIB.txt | Reports the software version of SafeNet Luna Network HSM appliance. |
Copy all MIBs in <Luna_HSM_Client_install_dir>/snmp to the MIB directory on your system. Only the MIBs necessary for SafeNet Luna PCIe HSM and SafeNet Luna USB HSM are included in a client installation.
For SafeNet Luna Network HSM, the host is the appliance, so all the above MIBs are installed on the appliance. See SNMP Traps in the Syslog and SNMP Monitoring Guide for information on configuring SNMP trap notifications.
NOTE Your SNMP application also requires the following standard SNMP MIBs:
>SNMPv2-SMI.txt -- defined in RFC 2578, Section 2
>SNMPv2-TC.txt -- defined in RFC 2579, Section 2
